My flooring dilemma, what would you do?

Flooring Forum

Help Support Flooring Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

UniqueCopy

Member
Joined
Aug 11, 2014
Messages
5
Location
,
Rather than focusing on everything I have to do between now and the point where I'm actually ready for flooring, I've been distracted by which flooring I'm going to choose. I'd like to get it finalized, once and for all, so I can move on with the other aspects of this condo renovation!

The condo, my first home, is 2bd/1ba, 714 square feet, on the second floor of a two story complex. The living room, hall, and bedrooms were carpeted, which I've removed and disposed of to get a jump on minimizing the cigarette odor. The kitchen has hardwoods, which will be replaced. The current sub-floor is particleboard. I don't plan on every selling the place, though it'll likely be a rental in 5-6 years.

I want to have the same wood or wood-look flooring throughout, minus the bathroom. The look I'm going for is a smooth Brazilian Cherry (or Brazilian Cherry look) I must have looked at, decided on, then circled back on each type of flooring there is! I believe I've finally narrowed it down to two options, laminate or real hardwood. I don't like the look or feel of LVT. Engineered hardwood and bamboo seem to cost very close to the real thing, can't be refinished the same (a couple times or not at all), and don't have the upscale prestige of the solid wood. If I'm going to make the investment, I want to do it right, otherwise there's no reason for spending the extra money.

My main hang-up, of course, is the kitchen and potential damage. I've lived in three homes with hardwoods in the kitchen, and three relatives have had laminate in their kitchens for a few years now. None of them have had an issue, nor have I seen any issues in houses or rentals I've visited. I believe the majority were real hardwoods, it seems kitchen installs are fairly common in the Northwest. Again, just my experiences, this is why I'm asking you guys :)

My dilemma, in a sentence:

I'd like to go with real, solid hardwood floors, but I'm not sure if it would be worth the cost, since I've heard they're just as susceptible to water damage as laminate.

The pro's of hardwoods are numerous: I really like the warmth, look, and feel of a solid hardwood floor. Hardwood floors can be refinished many times (you don't see other 100 year old residential floors still in use today). Hardwood floors increase value and add upscale finish. The only negative is the cost, and that's what has me thinking about laminate. If it's true that they're just as susceptible to water damage, I think laminate is the way to go. Most people buy a few extra boxes, in the event they need to replaced damaged pieces. If I did go with laminate I could install it myself, and float it over the existing particle board. If I go with hardwood I'll have to lay a new subfloor (materials, I can do this myself), and hire a company for the actual flooring install. An upside is that it would likely have a warranty, right? Likely not against water damage, but other things?

I know you can't seal laminate, and I've read all kinds of mixed things about hardwoods. Some say you can seal them and it'll make them more resistant to water and UV fading. Some say you can't seal them, because they wouldn't be able to expand and contract. Which is it?

I believe I could install a decent laminate myself for around $3.50/sq ft, on the high end. This would total $2450.

I haven't shopped around for hardwoods, but earlier I called a reputable flooring company for a very rough, sight unseen, sq foot quote, to see if I could possibly afford it. I don't have a bunch of money, but I plan on living here for a long time, and I believe hardwood floors would be an investment. They quoted me $2.25 for the nail down installation (providing I lay and prep the plywood or OSB subfloor), and around $5.99 sq ft for the Brazilian Cherry flooring. This would total $5768, not including the materials for the new subfloor.

One last question about subfloors, do they all require two 'layers'? I'm guessing the answer will be yes, but if I have 3/4"-1" plywood under the particleboard (attached to the joists), do I still need to lay another sheet of subfloor, or can the hardwood be laid directly on that?

I'd really appreciate any and all input you guys could provide me.

Examples of the look I'd like:

6ec988a9fcddd6645059d7aa637c73da.jpg


e8384793e8d3a0c97d80e1cd5748886b.jpg


82268c69979efbf8ab3c58f80b514970.jpg


Photos of my condo:

http://imgur.com/a/uLfhO
 
Home owners insurance covers water damage. No one else. Laminate is kinda meh as far as resale value unless it's some of the european stuff I have. :)

Sound proofing with a naildown dont help as the fasteners transfer sound below unless you float a 3/4 ply with underlayment under it like cork. Not a fan of nailing through underlayments, see preceeding sentence.
 
Do they make click-lock hardwood that doesn't have to be nailed down?

UniqueCopy, (first of all, clever name) so you sort of like the reddish woods? The last one you posted, I personally wouldn't get because of the seams with little depressions. From my experience, it is a pain cleaning stuff like that because dirt is harder to get out.

My kitchen has hardwood parquet but it got ruined by water when the power was out for too long and ice in the freezer and melted and soaked the floor.

An alternative is vinyl plank that looks like wood. There are also egineered wood flooring products but I think those tend to be more expensive.
 
Thanks for the reply, Ernesto.

Hmm, I wonder how I'll be able to get around that rule.

Think carefully about it before you proceed. How would you feel if you had upstairs neighbors that installed hardwood floors without a noise barrier and every step sounded like horses dancing. :eek:
 
Today I verified, I have 1/2" particle board on 3/4" plywood on joists sitting 24" apart.

I've been thinking about it over and over again, and I'm now thinking engineered hardwood might be my best bet, then solid hardwood, then laminate. Honestly though, I think I'm going to opt for one of the two real woods.

As I mentioned, water damage is my biggest concern, since this will be installed in the kitchen. From what I've read, it seems that engineered hardwood is much more water resistant than solid hardwood. Is this correct? If so, I guess that's my best option...

For the flooring prep and installation, I'm a believer in the old adage "Your final result is only as good as your prep work". I want to make sure my subfloor is ready to quietly support a long relationship with my finish flooring. I'll be doing all the subfloor work myself. I'm not sure if I'll install the hardwood floor or if I'll have it installed, but I'm leaning toward the latter for warranty purposes. As I mentioned above, I have 1/2" particle board, on 3/4" plywood, on joists sitting 24" apart. I've read that, with the wide joist spacing, for solid hardwood floors, it's recommended I lay another sheet of plywood or OSB to bring the total subfloor thickness to 1"+, correct?

When it comes to the installation, what are the big differences in nail down, glue down, and floating, when it comes to potential issues longevity, and performance of the flooring? Only the engineered hardwood can/should be floated, right? How can I quantify whether it'd be worth the substantial expense of pulling the particle board and laying down another sheet of subflooring for a nail down installation? I don't hear of glue down installations much, is that something I should be considering for my installation, or should I choose between nail down and floating?

It appears the cost for engineered or solid is about the same. If floating an engineered floor is anything like installing laminate, I'm pretty sure I could do it myself. Cost for a nail down installation is around $2.25/sq ft, or $1575, plus the cost of laying 700 sq ft of additional subfloor.

Another question! My bottom cabinets are sitting on the current hardwood in the kitchen, so I assume I have to remove them for the install? Any chance of not cracking my tile countertops?

Do they make click-lock hardwood that doesn't have to be nailed down?

UniqueCopy, (first of all, clever name) so you sort of like the reddish woods? The last one you posted, I personally wouldn't get because of the seams with little depressions. From my experience, it is a pain cleaning stuff like that because dirt is harder to get out.

My kitchen has hardwood parquet but it got ruined by water when the power was out for too long and ice in the freezer and melted and soaked the floor.

An alternative is vinyl plank that looks like wood. There are also egineered wood flooring products but I think those tend to be more expensive.

I believe they do, but I've only seen it in the engineered type.

Thanks for the compliment on the name. I do like the reddish woods, the Brazilian Cherry/Jatoba to be specific. Good call on the ease of cleaning, didn't think about that.

I've thought about the vinyl plank, but it looks and feels too cheap to me.

Think carefully about it before you proceed. How would you feel if you had upstairs neighbors that installed hardwood floors without a noise barrier and every step sounded like horses dancing. :eek:

Sorry Dennis, that came out wrong. I meant from an installation perspective. I want and will pay for as much noise mitigation as I can afford. I'm definitely not trying to be cheap or inconsiderate.
 
It looks like you have enough open space to use the Triangulo Engineered 5" wide with boards up to 72" long Brazilian Cherry Flooring. I have these now but got water damage from my water heat so since I have so much furniture due to an home office, I would like more color variation since I do not have so much floor showing. Hence, I am replacing the floor with a floated 3.25" Triangulo Engineered wood floors with boards up to 48".I floated the first floor with a floor muffler and it was quiet and felt like a hardwood floor. My floor is concrete and I live in a townhouse. The store is going to you the Whisper Quiet this time to insulate my floor a little more since concrete gets so cold. I also love the reddish wood floors and I love my Brazilian Cherry Floors that were installed in September 2009. The wood is a sawn cut (to look exactly like a solid hardwood floor) 3 MM thick over plywood.

By the way, I love your tall kitchen cabinets with no soffit. You have a beautiful condo.
 

Latest posts

Back
Top